That's because we offer a selection of indoor air quality
products no one else can match-including air purification systems,
air cleaners, filtration systems, humidity-control systems and
ventilation systems.
Featured Product
Tankless Water Heater
The T-K3-OS has a built-in power venting system and was designed
specifically for outdoor installations. The T-K3-OS does not
require any additional Category III venting or vent caps, making
installation one step easier for its installers.
Find out more
Did You Know?
Tank Operation: A tank-type heater stores a volume of water at
an approximate set temperature 24/7/365. As you draw hot water at
your fixture, cold water replaces the outgoing water in the tank
and the temperature of the water in the tank begins to drop.
- If the tank has been set to a high temperature (which wastes
energy and shortens its life) and the flow rate is fairly low, it
will provide adequate hot water for one reasonably long
shower.
- If the tank is set near the ideal 120°F, one shower will
start to "run cold" in as little as 15 minutes!
Tankless Operation: Takagi units operate differently. Each unit
modulates fully between its minimum and maximum BTU/hr input
ratings. It only uses the amount of gas needed to do the job, so
there's no waste!
- A Takagi water heater requires a minimum flow of 0.75 GPM (the
T-K3=0.50 GPM) to initiate the burner. Without this minimum flow,
the heater may continuously run and heat exchanger would
overheat.